Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hello Everyone, I'm working on NX

Status
Not open for further replies.

Khaledtr

Automotive
Joined
Sep 4, 2022
Messages
3
Location
TN
Hello Everyone,
I'm working on NX 12 and I'd find a method to insert the assembly mass to the drawing/title block via an attribute, what I understood that the only way is to use a journal. I find something interesting in this Thread thread561-485834 and I tried to apply the suggested journal by Mr.niedzviedz (Mechanical) Just I'd modify this journal to make it write the attribute of mass (mass.prt) to the assembly instead of part and this attribute must be the sum of the mass of parts to be able to use it in the drawing.
Thanks in advance
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top