Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hello everyone. I have one issue

Thread starter Akash.
Start date Jan 5, 2022

Status: Not open for further replies.

Jan 5, 2022

Akash.

Student

Hello everyone.

I have one issue in NX Drafting.

I have created some points in 3D modelling environment (say 100 points).
Now I want to show X,Y,Z cordinates as a note with leader in Drafting for all.
Must able to select multiple points at a time.
Must place leader automatically similar to auto baloon.
How can I do this?