Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Helical Rotor and Stator

Status
Not open for further replies.

shanky1023

Mechanical
Joined
Jun 13, 2010
Messages
4
Location
US

I need to have a HELICAL rotor and a stator.. But the catch is i need the STATOR to have twice the pitch length but same minor diameter as the rotor... i am just unable to get a helical shape with two starts to it. Could anyone please help me out in this..
I have a picture attached to help better visualisation
 
shanky1023,

Have you tried getting a 3D model from a vendor that makes these? You might also try 3DContentCentral.

- - -Dennis
 
"i am just unable to get a helical shape with two starts to it"

Can you make one helical shape (single start), and then use a Circular Pattern to create the 2nd 'start'?
 

i tried a lot in 3D- Content central but could not get the any model.. I will try the vendors option and the circular pattern option today and see how it goes..

Shankar
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top