HEC-HMS Paired Data Entry

[smaug6]

In the past when I have used HEC-HMS I have usually manually entered my paired data table data manually. For some reason when I do this the data won't stay in the table. Why is this? I have never had this problem before.

 

[SMIAH]

You have to click on the "apply" button.

 

[smaug6]

SMIAH Thank you very much! Where is the apply button? It has been a while since I have used the program.

 

[SMIAH]

See picture attached

 

[smaug6]

SMIAH, Well I found that button but unfortunately when I use it all data entered into the table instantly and un-explainably disappears??!?!

http://files.engineering.com/getfil...8d9-bedc-c1b00b463d3a&file=Prior_to_Apply.jpg

http://files.engineering.com/getfil...9b-48cb-80b7-ef15ba06a517&file=Post_Apply.jpg

Also I can open files created in version 3.3 and they will run but no output is displayed?!?!? I get this message

http://files.engineering.com/getfil...ca-a572-474ecce983be&file=HEC-Error_13000.jpg

I considered deleting 3.4 and running 3.3 but for some reason I can't delete that program file folder?

 

[smaug6]

Never mind I deleted 3.4 and 3.3 runs. Thanks again for the assistance.