Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Heatpump discharging on condensor
- Thread starter pumpmann
- Start date
EnergyProfessional
Mechanical
you could jsut use a heat recovery chiller...or oemthign liek that.
if you do that outside, msot of the cold air will disspate before it hits the condneser. If you duct it, you need to make sure both run at the same time or that the condenser gets fresh air otherwise. When ducting, the added ai pressure drop and more fan energy may offset any savings.
Not sure hwat isze of system, but whne you simultaneous heat and cool there are ready-made solutions.
if you do that outside, msot of the cold air will disspate before it hits the condneser. If you duct it, you need to make sure both run at the same time or that the condenser gets fresh air otherwise. When ducting, the added ai pressure drop and more fan energy may offset any savings.
Not sure hwat isze of system, but whne you simultaneous heat and cool there are ready-made solutions.
NegativeZero
Mechanical
- Oct 4, 2013
- 31
and what do you do when the heat pump is in cool mode? I don't think there is any written material on this design build setup.
EnergyProfessional
Mechanical
obviously you will need some sort of heat rejection. 99.999999% of the time heating and cooling load won't match.
- Status
Similar threads
- Question