I am just trying out this software out and evaluating it for my needs.
I was wondering if anyone out there has had any experience with it (good or bad) and can give any comments?
I am wanting to use it for tank / vessel design for non-critical carbon steel fabrications.
The operating pressures are full vacuum to atmosphere with just air & water vapor.
I can't quite justify the $ for higher end software at this time.
I was wondering if anyone out there has had any experience with it (good or bad) and can give any comments?
I am wanting to use it for tank / vessel design for non-critical carbon steel fabrications.
The operating pressures are full vacuum to atmosphere with just air & water vapor.
I can't quite justify the $ for higher end software at this time.
lease see FAQ731-376 for tips on how to make the best use of Eng-Tips.