I´m working on a hydraulic application where I need to design a coulping between a hydraulic motor and a chain saw sprocket. I´m amazed that not even the company who gave me the mission can´t help me with data on the splines used on close to all chainsaws of the world and all I can get from chainsaw manufacturers is that there are two major sizes available, "small" and "standard" both with 7 teeth. Can anyone out there help me with informations on, or where I can find dimensional specs. for at least the so called "standard" seven tooth spline.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
hard to find "standard" splines
- Thread starter LennartR
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question