Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

H7 Tolerance for +540mm? 1

Status
Not open for further replies.
Tagger

Tagger

Mechanical
Joined
Aug 10, 2001
Messages
47
Location
US
My ANSI B4.2-1978 Reaffirmed 1994 only goes up to 500mm which is +0.00/+0.067.
 
Sort by date Sort by votes
From 500 to 630 mm
H7 states:

+0.000/+0.070 standard desviation

SACEM1
 
Upvote 0 Downvote
Is there a book or someplace on the Internet that publishes these tolerances above 500mm?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

moiz19670309
  • Question Question
Hole size with tolerance for Shaft
Replies
7
Views
8K
Gr8blu
Gr8blu
D
  • Locked
  • Question Question
Confusion about positional tolerance for rectangular pins
2
Replies
21
Views
12K
Orange_kun
Orange_kun
Mech 3D
  • Locked
  • Question Question
Acceptable tolerance for surface defects on pressure piping
Replies
9
Views
5K
mfgenggear
mfgenggear
Poorpaulus
  • Question Question
Tightest realistic tolerance of a 200mm ID cylinder
Replies
11
Views
4K
GregLocock
GregLocock
L
  • Locked
  • Question Question
Help setting up a tolerance stack up analysis for a door latch assembly
Replies
1
Views
2K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top