When I drag a part into an assmebly I apply the needed relationships and when I check them it only has a grounded relationship and no others. I have uninstalled and reinstalled SE and no help. Some of the component parts are from previous revs., and I am working in V17.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
GROUNDED PARTS IN ASSEMBLIES
- Thread starter swhits
- Start date
beachcomber
Mechanical
swhits,
I had the same problem a while ago - this was Fred's answer.
"have you tried right clicking in the 'parts list' window in the edgebar when in the assembly environment : make sure that 'maintain relationships' is checked."
bc.
I had the same problem a while ago - this was Fred's answer.
"have you tried right clicking in the 'parts list' window in the edgebar when in the assembly environment : make sure that 'maintain relationships' is checked."
bc.
fredericmenage
Mechanical
Hi,
What beachcomber said should do the trick. Otherwise, it's maybe because your part is grounded to begin with. Then you need to delete the ground before adding relationships.
Fred
What beachcomber said should do the trick. Otherwise, it's maybe because your part is grounded to begin with. Then you need to delete the ground before adding relationships.
Fred
- Thread starter
- #4
- Status
Similar threads