Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

groundcheck and units

Status
Not open for further replies.
AREM

AREM

New member
Aug 20, 2015
1
Dear all,
The default value in groundcheck for the threshold is computed by dividing the largest term in the stiffness matrix by 1.E10.
I wonder if a conversion is required depending on units used in the model, eg. mm, m , inch...
Regards
 
Status
Not open for further replies.

Similar threads

P
  • Locked
  • Question
SOL401 and negative matrix diagonal
Replies
1
Views
1K
BlasMolero
BlasMolero
Spyros07
  • Locked
  • Question
Modal stiffness and mass matrices extraction
Replies
3
Views
1K
jamesdean2
jamesdean2
Callumcmcl
  • Locked
  • Question
Bodies in impact and explicit dynamics analyses won't make contact
Replies
1
Views
694
SWComposites
SWComposites
Emi.Cor
  • Locked
  • Question
Glue and Touch contact on the same SOL 101 analysis. 2
Replies
3
Views
2K
Emi.Cor
Emi.Cor
Alberto94
  • Locked
  • Question
Unit enforced displacement and rotation validity check
Replies
2
Views
442
Alberto94
Alberto94

Part and Inventory Search

Sponsor

Back
Top Bottom