Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

groundcheck and units

Status
Not open for further replies.

AREM

New member
Joined
Aug 20, 2015
Messages
1
Location
FR
Dear all,
The default value in groundcheck for the threshold is computed by dividing the largest term in the stiffness matrix by 1.E10.
I wonder if a conversion is required depending on units used in the model, eg. mm, m , inch...
Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top