Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Grip Question again

Status
Not open for further replies.

smitty239

Automotive
Joined
Jan 4, 2007
Messages
60
Location
CN
Hi Guy's
is there anyway using grip to change the transparancy of a block lets say to 50%. I have been looking everywhere but can't seem to find anything on this.
Thanks again
Bob Smith
 
I doubt it. GRIP has been on life support since UG V11 and not enhanced since then. Very few commands dealing with solids were added to GRIP except the abilty to create them at V7.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
Sr IS Technologist
L-3 Communications
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top