eroque
Civil/Environmental
- Jun 20, 2016
- 92
Hello,
So, i am running a complex model in Abaqus, where i must have a lot of nodes and elements.
In order to simplified the number of nodes i tried a very reduced mesh but the anex error message appeard. When i click yes a grey mesh appears but when i ru the model Abaqus does not reconginze that mesh. I know that this is an invalid mesh but there is any way to convert this greu mesh into a valid mesh ? If Abaqus can generate this grey mesh why is not valid ?
I don´t want to increase the number of nodes, i want the grey mesh. Ideas ?
Thank you in advance.
So, i am running a complex model in Abaqus, where i must have a lot of nodes and elements.
In order to simplified the number of nodes i tried a very reduced mesh but the anex error message appeard. When i click yes a grey mesh appears but when i ru the model Abaqus does not reconginze that mesh. I know that this is an invalid mesh but there is any way to convert this greu mesh into a valid mesh ? If Abaqus can generate this grey mesh why is not valid ?
I don´t want to increase the number of nodes, i want the grey mesh. Ideas ?
Thank you in advance.