Does anyone know of a good design reference for natural (gravity) ventilation. This is typically used on large industrial buildings (foundries, etc.), and consists of continuous weatherproof ridge venting and inlet air louvers set low in the sidewalls of the building.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Gravity Ventilation 1
- Thread starter butelja
- Start date
-
1
- #4
Robertson make ridge-line ventilation outlets which have specially-shaped louvers to take advantage of wind velocity to produce a pressure drop and therefore suck air up through the building. I have installed some of these on a power station and they were very effective.
Look up the site
they make a significantly improved
ventilator to the Robertson design
and are available to size up any
industrial ventialtion requirements
they make a significantly improved
ventilator to the Robertson design
and are available to size up any
industrial ventialtion requirements
- Status
Similar threads
- Locked
- Question
- Locked
- Question