Global Interference Check

[meganine]

Does anyone know how to run a global interference check?

I'm sick of having to click on each and every part in my assembly every time I want to check it.

I'm using v11.

Thanks,
Chris

 

[swertel]

There is a parameters tab in the Ribbon Bar that you set for what consitutes selection set 1 and 2. In there should be a setting to do a global check. I haven't used v11 for quite some time, but I think it was in there and not something new to v12 and on.

--Scott

For some pleasure reading, try FAQ731-376