Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Global Interference Check

Status
Not open for further replies.
meganine

meganine

Mechanical
Joined
Feb 21, 2003
Messages
17
Location
CA
Does anyone know how to run a global interference check?

I'm sick of having to click on each and every part in my assembly every time I want to check it.

I'm using v11.

Thanks,
Chris
 
Sort by date Sort by votes
There is a parameters tab in the Ribbon Bar that you set for what consitutes selection set 1 and 2. In there should be a setting to do a global check. I haven't used v11 for quite some time, but I think it was in there and not something new to v12 and on.

--Scott

For some pleasure reading, try FAQ731-376
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

LeonorCH
  • Locked
  • Question Question
Checklist of features
Replies
1
Views
190
swertel
swertel
Howerd
  • Locked
  • Question Question
How to snap to 1.0mm grid globally
Replies
7
Views
302
beachcomber
beachcomber
Kenny_G
  • Locked
  • Question Question
Anyone going to the ST4 Global Launch Event on June 15-16?
Replies
3
Views
177
lapuser
lapuser
flipeng
  • Locked
  • Question Question
Check Interference in Assembly Mode - "Save as Part" Output Fails
Replies
0
Views
104
flipeng
flipeng
arno4012
  • Locked
  • Question Question
CheckInterference with VBA
Replies
5
Views
197
arno4012
arno4012

Part and Inventory Search

Sponsor

Back
Top