Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Glasses strenght

Status
Not open for further replies.

KFrenos

Automotive
Mar 1, 2002
1
What is the relationship between cost and resistance of the following glasses?

- 5 mm tempered glass + butiral sheet in one side
- 4 mm tempered glass + butiral sheet + 4 mm tempered glass

Can I obtain data about these two different glasses (differences if you use a single glass or a double glass,
resistance curve evolution to break increasing the width,...).
 
Replies continue below

Recommended for you

Could it be of help to specify a little bit?

Do you think to have the foil not covered on 1 side
or is that wrong? In general it doesn't seem appropriate to not cover both sides of the foil. The foils's resistence is not strong enough. On the other hand the foil is not transparent in i'ts originl state (before autoclaving)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor