I have been trying to create a surface in 3-D so that I can do a drive-thru. When I interpolate between sections it keeps telling me I have color mismatch and when they finally do interpolated I have twisted surfaces and warped surfaces in relationship to my design. any ides?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Geopak 3-D Surfacing
- Thread starter namdac
- Start date
Try this again over on the Geopak forum, you might g
et better response... Robert Weber, EI
Maurer-Stutz, Inc
"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."
et better response... Robert Weber, EI
Maurer-Stutz, Inc
"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."
Try this again over on the Geopak forum, you might get better response... Robert Weber, EI
Maurer-Stutz, Inc
"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."
Maurer-Stutz, Inc
"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
