Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Generating an OK shortcut in Catia V5
- Thread starter CAD_ROB
- Start date
TiagoFigueiredo
Industrial
For general message windows, I use directly the space bar, enter key does the same.
The suggestion made by Wuzhee, doesn't work for for other catia windows, like pad, hole, powercopy...
For general windows, like pad, hole, powercopy. I had configured a key in my mouse, with enter key. If Ok button, was the last selected it works! If not, then I have to make the tedious work of clicking the OK button. In CREO and NX, by pressing middle mouse button the commands are accepted, and that's good!
Tiago Figueiredo
Tooling Engineer
Youtube channel:
The suggestion made by Wuzhee, doesn't work for for other catia windows, like pad, hole, powercopy...
For general windows, like pad, hole, powercopy. I had configured a key in my mouse, with enter key. If Ok button, was the last selected it works! If not, then I have to make the tedious work of clicking the OK button. In CREO and NX, by pressing middle mouse button the commands are accepted, and that's good!
Tiago Figueiredo
Tooling Engineer
Youtube channel:
- Status
