Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

general sizing/use of std. ASCE crane-rail sections

Status
Not open for further replies.
KnarfMan

KnarfMan

Civil/Environmental
Feb 7, 2002
12
Hi,
Was wondering if anyone can tell me "ballpark" ASCE crane-rail section sizing for overhead cranes? Or is it really dependent on wheel loadings? Any site-links would be appreciated. TIA
 
Replies continue below

Recommended for you

Sort by date Sort by votes
AISC Journal had a good article by Dave Ricker on industrial cranes in the Fourth Quarter, 1982. It may still be available from AISC.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Eng_Struct
  • Question
Rail Offset On Crane Runway Girders 1
Replies
7
Views
3K
Ron247
Ron247
FLR84
  • Question
Achieving 10mm crane rail support deflection limit while not overdesigning the column and footing? 1
Replies
3
Views
2K
FLR84
FLR84
QA_Manager
  • Locked
  • Question
Bar Rail V ASCE T-Rail 1
Replies
2
Views
233
FLCraneBuilder
FLCraneBuilder
Larryhd2
  • Locked
  • Question
ASCE 7-16 vs 7-22... use higher Sds?
Replies
7
Views
3K
Aesur
Aesur
B
  • Question
Crane Side Thrust Loads
Replies
6
Views
5K
B.Fallah
B

Part and Inventory Search

Sponsor

Back
Top Bottom