Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gear Position. 1

Status
Not open for further replies.

yguns26

Electrical
Joined
Oct 20, 2002
Messages
3
Location
AU
Halo, anybody knows any way to determine a gear position? i.e the gear of a motorbike is undetermine since is only an up and down, is there any ways to determine the position except by counting the number of times that gear have been tap.
 
is that accurate? i.e is there a certain curve or graph can be used to determine the gear position from the roadspeed and the engine speed? (kph / rpm). can the gear position be determined by the pressure between the linkage rod (from gear box to gear lever).i.e change in pressure= change in gear. any idea to this?
thnx
 
It is measuring the gear ratio. It is very accurate once the clutch is fully engaged.

There will be no force in the linkage after the gear is engaged, and the force during the change will not just (in fact not much at all) depend on the two gears that you are switching between.

Cheers

Greg Locock
 
On a bike, with their sequential shifting, why do you want to know what gear it's in?
If you are at low RPM and/or want more response, change down one, and vice versa.
Different story in a car with "H" pattern gates.
Regards
pat
 
I don't know about yguns26, but a gear indicator on a bike/bike engined car, is a very useful thing. They're not overly blessed with torque, and have to be kept "on the boil", so knowing what gear you're in is a very useful thing.
In a bike engined car, the gear selection is sequential, as on the bike, so there isn't the H pattern to judge which gear you're in, which can be very frustrating. I know, I race one.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top