Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

gear mesh frequency is > f max what can i do ?????

Status
Not open for further replies.

thebeginervibration

Mechanical
Joined
Feb 22, 2012
Messages
4
motor 2960 rpm drive apump whic have two shafts the first is the low speed shaft 2960 rpm have axial gear with 191 teeth and the second is The high speed shaft 21772 rpm have axial agear with 26 teeth mesh with the first gear as we all know GMF =no of teeth*rpm so
191*2960 = 565360 cpm = 9422 hz
by using Prime Number Theory 191= 191*1
26=13*2*1 so
(LCF)Largest Common Factor = 1
the first problem that the f max =8000 hz i can not see the GMF
and the seconde problem is 1/2 GMF is present but i confused with 13X AND Eccentricity WHICH will also cause fractional harmonics of GMF
1/2 GMF =4721 HZ = 13X AND THE TIME WAVE FORM IS SO COMPLICATED PLZ HELP
SEE ATTACHED SPECTRUM AND TWF
 
If you haven't set your data acqusition up with a sufficiently high sampling speed there is nothing you can do with the resulting data to show GMF.

As to your other observations, um, yes it is complicated. You seem to have a good handle on the possibile causes.

I am used to varying the speed of the box and plotting Campbells diagrams rather than trying to figure out what is happening from a single speed.

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top