GE EB-25 Marking Strip Width?? 1

[dpc]

I'm trying to figure out the width of the marking strip that runs down the middle of the EB-25 terminal block, but there's nothing GE has that shows it.

Anybody got one sitting around they could measure?

Danke,

dpc

 

[rbulsara]

Can you try scaling from this?

http://www.gedigitalenergy.com/products/brochures/eb25.pdf

Rafiq Bulsara

http://www.srengineersct.com

 

[rbulsara]

My scaling on the screen works out to be 1/4".

Rafiq Bulsara

http://www.srengineersct.com

 

[catserveng]

DPC,

Just pulled one out of hte truck and measured it.

.435" wide

Mike L.

 

[dpc]

Mike,

Thanks. I was guessing it was 0.5", so I was a little optimistic.

Thanks again for the help. Have a good weekend.

Dave

David Castor

http://www.cvoes.com

 

[rbulsara]

So much for my scaling..perhaps off by factor of 2, the picture that is..

Rafiq Bulsara

http://www.srengineersct.com

 

[catserveng]

Dave,

No worries, your timing is good, I normally don't have them on my truck, but I have a job Sunday where I have to add a couple to a set of gear, so it worked out!

Mike

 

[dpc]

Rafiq,

That photo in the GE brochure is horrible - not much to work with.

Cheers,

Dave

David Castor

http://www.cvoes.com