GD&T feature control frame preferences 2

[Trietsch]

Hello,

I'm trying to default the tolerance set to off (un-ticked) for feature control frame... I can't seem to find the setting anywhere. Any help would be greatly appreciated. My users see different behavior from different drawing templates so I assume it is a setting within the template or unit specific site preference. Image attached.


NX6.0.5.3 MP12 / TC8.3.0 currently, NX8.5.3 MP8 / TC8.3.3.6 very soon.

Thanks,
Ryan

 

[JohnRBaker]

OK, that option, the 'Unit Basic Value', is controlled by Dialog Memory, in that if it's toggled ON it will remain that way until you toggled it OFF in the future, irrespective of what part file you have open.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Trietsch]

Perfect! Thank you John! I'll test it out and you've probably got a start coming.

that sure is an easy fix from the admin side... hehe

 

[Trietsch]

Well done John. perfect answer as usual