arvindpandit
Mechanical
Hi....
Please let me know how to select the gasket from ASME VIII-I Appen-2 table for flange design?
Please let me know how to select the gasket from ASME VIII-I Appen-2 table for flange design?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Gasket
- Thread starter arvindpandit
- Start date
- Status
racookpe1978
Nuclear
Open table.
Read table.
Know information about flange size, spec, fluid type + pressure + flow + temperature + safety and specifications requirements.
Apply knowledge.
yes - I am being slightly sarcastic. There is not information provided (from you) to help you with your question.
Read table.
Know information about flange size, spec, fluid type + pressure + flow + temperature + safety and specifications requirements.
Apply knowledge.
yes - I am being slightly sarcastic. There is not information provided (from you) to help you with your question.
- Thread starter
- #3
arvindpandit
Mechanical
ok ....
There is one lube oil Cooler (S&T Heat Exchanger AES type).
Design Pr. Shell side 10.55 and Tube side 10.55
Design Temp. shell side 149 deg C and Tube side 75 deg C
Fluid Shell side is Lube oil and Tube side is cooling water.
shell ID 489 mm
Tube length is 3658 mm.
I think these informations are sufficient to help my question.
pls let me know if any thing else required.
What type of gasket should I select to design the flange?
There is one lube oil Cooler (S&T Heat Exchanger AES type).
Design Pr. Shell side 10.55 and Tube side 10.55
Design Temp. shell side 149 deg C and Tube side 75 deg C
Fluid Shell side is Lube oil and Tube side is cooling water.
shell ID 489 mm
Tube length is 3658 mm.
I think these informations are sufficient to help my question.
pls let me know if any thing else required.
What type of gasket should I select to design the flange?
- Status
Similar threads
- Locked
- Question