Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Galvanic Corrosion between A7050 and A2024 and A7075 1

Status
Not open for further replies.
iamchoyh

iamchoyh

New member
Joined
Jan 26, 2001
Messages
6
Location
KR
Hi..

I was searching the galvanic table from Mil-Std-889.
But, there are no information of the other al-alloy.
(ex:A7050...)
If I select the other al-alloy, Is it safe?
I don't think like that...
and There isn't showing the effect of heat-treat...

I need the informations...

Thank a lot.
 
Status
Not open for further replies.

Similar threads

asalisbury
  • Question Question
Edge Deburring and Faceting Tools
Replies
2
Views
617
MintJulep
M
SAEEDGH
  • Locked
  • Question Question
find equal belt between megadyne and power grip timing belt
Replies
3
Views
559
Jboggs
Jboggs
M
  • Question Question
ANSYS - Tube Bending and Measured Ovality
Replies
6
Views
3K
MECHENGTOM
M
Helepolis
  • Question Question
Standard for keys and keyways/keyseats design (Aircraft)
Replies
8
Views
8K
EdStainless
EdStainless
morganwz
  • Question Question
Acceptance limits for corrosion on threads during overhaul
2
Replies
20
Views
7K
desertfox
desertfox

Part and Inventory Search

Sponsor

Back
Top