Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
GAGING SLOTTED LOCKNUT CENTERLINE???
- Thread starter ONPHIRE82
- Start date
It depends upon how it is shown on the drawing. If, as an example, it is shown in GD&T as a positional tolerance at MMC, then one can make a checking fixture.
If it is shown without GD&T, then one could use a CMM (co-ordinate measuring machine). Of course, one can also perform symmetry using tool room equipment with a index head and height gage with dial indicator.
These are some of the ways.
Dave D.
If it is shown without GD&T, then one could use a CMM (co-ordinate measuring machine). Of course, one can also perform symmetry using tool room equipment with a index head and height gage with dial indicator.
These are some of the ways.
Dave D.
- Thread starter
- #3
We really need the drawing here and then I can help you. You can send it to my e-mail address as an attachment. I will be out of town during this week but will pick up my e-mail in the evening.
Dave D.
Dave D.
I think page 52 of this .pdf shows a gaging method (text is in German, which can be translated by Google):
- Status
Similar threads
