Hi all,
We are currently in the construction phase of a new RECIP powerplant. It will also integrate a new and modernized control room, which includes a large videowall where operators can view all the necessary parameters of the powerplant.
I was wondering if anyone could share a list (and reason) of the essential parameters a Powerplant operator should need to monitor for a safe and reliable operation.
Average load approximately 110 MW distributed to 9x Substations managed by an external company.
An overview of the Powerplant:
All IC-Engines running on LFO/HFO:
6x of 7.4 MW
4x of 11.4 MW
6x of 17.5 MW
Renewables + Energy Storage:
1x 6 MW (Solar Park)
1x 30 MW (Wind Park)
1x 21 MW (Wind Park)
Backup/ Emergency:
1x 21 MW (Gas Turbine)
The powerplant is integrating an Intelligent Load Shedding scheme for the loads and Intelligent Load Sharing amongst the IC-Engines.
Thanks in advance for any feedback.
We are currently in the construction phase of a new RECIP powerplant. It will also integrate a new and modernized control room, which includes a large videowall where operators can view all the necessary parameters of the powerplant.
I was wondering if anyone could share a list (and reason) of the essential parameters a Powerplant operator should need to monitor for a safe and reliable operation.
Average load approximately 110 MW distributed to 9x Substations managed by an external company.
An overview of the Powerplant:
All IC-Engines running on LFO/HFO:
6x of 7.4 MW
4x of 11.4 MW
6x of 17.5 MW
Renewables + Energy Storage:
1x 6 MW (Solar Park)
1x 30 MW (Wind Park)
1x 21 MW (Wind Park)
Backup/ Emergency:
1x 21 MW (Gas Turbine)
The powerplant is integrating an Intelligent Load Shedding scheme for the loads and Intelligent Load Sharing amongst the IC-Engines.
Thanks in advance for any feedback.