Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Friction Loss in Half Open Gate Valve
- Thread starter Chance17
- Start date
georgeverghese
Chemical
If a generic profile for Cv vs valve opening is not available in the referenced edition of Crane, then would say this question is impossible to answer in the context of an exam, unless the question also says to assume a linear profile ??
While I agree the exam question is (at least based on just what is posted here)technically not well or fully qualified for rigorous answer, is it possible the framer of the exam question simply wanted the head loss calculated, or calculation procedure explained, e.g. working from a head loss coefficient published in some edition e.g.
- Status
Similar threads
- Locked
- Question
