Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Frames

Status
Not open for further replies.
Deso

Deso

Mechanical
Joined
Aug 18, 2005
Messages
1
Location
ZA
When I add a section to the line segment in frames, it automatically seats in the centre of the assembly reference planes.What setting do I change for it to follow the line? Any help please
 
Sort by date Sort by votes
Check this thread.

thread562-124752

fwc
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

eatfood
  • Locked
  • Question Question
Proper method of drafting structural frames of welded tubes
Replies
4
Views
459
eatfood
eatfood
ranchero
  • Locked
  • Question Question
Frames - How to miter a non-corner location?
Replies
1
Views
150
teebarr
teebarr
karmoh
  • Locked
  • Question Question
Frames - Help please
Replies
9
Views
341
beachcomber
beachcomber
beachcomber
  • Locked
  • Question Question
Why no improvement in frames utility?
Replies
9
Views
280
HDS
HDS
beachcomber
  • Locked
  • Question Question
Frames command - positioning the cross-section.
Replies
8
Views
227
beachcomber
beachcomber

Part and Inventory Search

Sponsor

Back
Top