Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Frames

Status
Not open for further replies.
Deso

Deso

Mechanical
Aug 18, 2005
1
When I add a section to the line segment in frames, it automatically seats in the centre of the assembly reference planes.What setting do I change for it to follow the line? Any help please
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Check this thread.

thread562-124752

fwc
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

eatfood
  • Locked
  • Question
Proper method of drafting structural frames of welded tubes
Replies
4
Views
332
eatfood
eatfood
ranchero
  • Locked
  • Question
Frames - How to miter a non-corner location?
Replies
1
Views
122
teebarr
teebarr
karmoh
  • Locked
  • Question
Frames - Help please
Replies
9
Views
269
beachcomber
beachcomber
beachcomber
  • Locked
  • Question
Why no improvement in frames utility?
Replies
9
Views
212
HDS
HDS
beachcomber
  • Locked
  • Question
Frames command - positioning the cross-section. 1
Replies
8
Views
183
beachcomber
beachcomber

Part and Inventory Search

Sponsor

Back
Top Bottom