Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fracture modeling

Status
Not open for further replies.

samlukeben

Petroleum
Joined
Jun 24, 2002
Messages
16
Location
GB
Does anyone know how to convert the non Darcy flow factor, Beta, from units of atm·s²/g to units of /ft ? It's not obvious how you would do this, and an internet trawl has so far failed to help...
 
Samlukeben,
Just convert 1 atm =14.7 psi*(32ft/s2) =14.7*144 Lb/ft2 *32 ft/s2
Now replace 1gm =1000/2.2 lbs

Now you have your conversion factor to convert atm.s2/g to 1/ft.

Hope this helps.

cheerz
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top