Form mill tools in nx

[EngMfg1]

I have created an assembly of a custom made tool I have assembled the tool , holder and pull stud how do get the whole assembly to appear properly in ugs verify, in the replay and dynamic, with right cut dia.


I have sample files if needed...

 

[metman]

You might have better response by posting this in the Engineering Computer Programs/UGS:solid Edge.

 

[looslib]

You need the kinematic simulation license. Not sure of the actual name, but it is required to display the motion of a spinning cutter during verification.

Try the UGS-NX tips forum or better yet, the UGS bbsnotes.

"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand

 

[EngMfg1]

I don’t need the form tool to spin, I just need it to appear on the screen.