M
maesoph
Guest
Dear All:
I would like to run a basic heat transfer problem to "bracket" the range of H values for simple forced convection. Basically, I want to set up a single part problem and run a forced convection analysis over a broad range of H values. Once I get this information, I can correlate the temperature changes vs. H to known temperature changes vs. air speed. Is there any way to automatically change the H value and track this data automatically???
I would like to run a basic heat transfer problem to "bracket" the range of H values for simple forced convection. Basically, I want to set up a single part problem and run a forced convection analysis over a broad range of H values. Once I get this information, I can correlate the temperature changes vs. H to known temperature changes vs. air speed. Is there any way to automatically change the H value and track this data automatically???
