Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Force of installation

Status
Not open for further replies.
eichman

eichman

Automotive
Joined
Apr 29, 2010
Messages
8
Location
IN
Hello,

Is there a formula to calculate the force (Push or Pull) required to install a Pin which has O-rings and back-up rings on it into a Box?

Thank you for your suggestions
 
Status
Not open for further replies.

Similar threads

dgeesaman
  • Question Question
Decreasing operating range of seal elements over the years
Replies
0
Views
6K
dgeesaman
dgeesaman
BasakAbhishek
  • Locked
  • Question Question
Estimation of torque in stuffing box of pumps
Replies
5
Views
3K
BasakAbhishek
BasakAbhishek
BasakAbhishek
  • Locked
  • Question Question
Sealing of gases by lip type seal
Replies
7
Views
4K
SB1976
SB1976
moon161
  • Locked
  • Question Question
Dry gas instead of liquid for leak test in pump w/ mech seal.
Replies
4
Views
2K
A8yssUK
A8yssUK
MechyMarco
  • Locked
  • Question Question
PEEK Piston Cap Instead of PTFE?
Replies
0
Views
297
MechyMarco
MechyMarco

Part and Inventory Search

Sponsor

Back
Top