I am performing a CU test on Flyash and am having problems achieving B-parameter saturation. Due to the consolidation pressures I can not increase the back pressure and cell pressures further. I am reading only about 80% B value. What are the procedures for CO2 saturation? I have a tank of 25% CO2 and 75% Argon I used for welding and was wondering if that would work. Can I do this even though I have alread been using deaired water up to this point? I have also run water up thru the sample to help satuation but I am not able to achieve over 80%. Thanks in advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flyash Saturation using CO2
- Thread starter GTSLABS
- Start date
GTSLABS,
Try the following thread:
or try searching the forum for "fly ash" "saturation" "b-value"
Good Luck
Jeff
Jeffrey T. Donville, PE
TTL Associates, Inc.
Try the following thread:
or try searching the forum for "fly ash" "saturation" "b-value"
Good Luck
Jeff
Jeffrey T. Donville, PE
TTL Associates, Inc.
- Status
Similar threads
- Locked
- Question
- Locked
- Question