Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fluke 435-II

Status
Not open for further replies.
vreijb

vreijb

Electrical
Joined
Nov 22, 2006
Messages
38
Location
CA
I would like to know if I need to change the fluke 435 default current Range 3000A to be close to load current or keep as is to start measurement as the manual suggest.
The panel I will connect has total load of 100A.
 
Sort by date Sort by votes
Keeping it in the default setting will be fine.

Mike
 
Upvote 0 Downvote
Thanks.
If you measure a panel with 3 phase 3 wire, which connection to be made? Delta or Y IT on the fluke.
I guess both should work.
 
Upvote 0 Downvote
Connections are straightforward per the manual.

Mike
 
Upvote 0 Downvote
Not really in this case.
I got Fluke Technical support recommendation to use Delta. I got feedback from experienced technician to use Y-IT.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

rafael gutierrez
  • Locked
  • Question Question
Calibration PQM II
Replies
1
Views
151
thermionic1
thermionic1
OffTap100
  • Locked
  • Question Question
Manual for Pennsylvania 3 phase 12mva 69000/4350Z- 2510
Replies
2
Views
156
OffTap100
OffTap100
Mostafaelec86
  • Locked
  • Question Question
Fluke 87 problem
Replies
5
Views
268
ScottyUK
ScottyUK
mls1
  • Locked
  • Question Question
Class II Div 2 Equipment
Replies
4
Views
671
mls1
mls1
BSEEDan23
  • Locked
  • Question Question
Why is a 7.5 Watt light bulb used in series w/fluke when doing in service readings on POTS
Replies
4
Views
221
ScottyUK
ScottyUK

Part and Inventory Search

Sponsor

Back
Top