Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FLOOPS again :(

Status
Not open for further replies.

balutan

Electrical
Oct 3, 2005
10
I am trying to simulate the growth of thin oxide (between 2-5nm) with FLOOPS. So I type the following code/command (which is basic oxidation)

diffuse temp=1000<C> time=10.0<s> O2

How can I tell the software while model I want it to simulate? Obviously Deal-Grove model will be wrong in this case and Massoud Model should be used instead. But is the software smart enough to know which model to use automatically with the above code? Can someone give me an ideal of how it should be done? Thanks.

I READ the manual and I don't find it helpful.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor