Flattening a harness in Creo across a splice

[Zrider]

I've an issue in Creo when flattening a harness. Two 6 gauge wires route to this splice from one direction with one wire stopping at the splice and the other continuing to a second splice. There are two separate bundles/looms on either side of the affected splice. The harness routes clean in the model, but when flattening, the harness routes fine to this splice, but shifts/offsets to one side of the splice after. Is there anyway to correct this? Hopefully I've described the issue well enough.

 

[design-engine]

is your splice a part with solids or is it a set of CSO coordinates? Maybe you can post an image of your splice part?

 

[Zrider]

the splice is a solid model assembled into the routed harness on a network point using 'insert component' and using the splice's 'entry_1' csys.

The pic is the flattened harness where the error occurs.

View attachment 6894

 

[design-engine]

is your splice the yellow dot?