Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flatness or Profile callout?

Status
Not open for further replies.
SeasonLee

SeasonLee

Mechanical
Joined
Sep 15, 2008
Messages
918
Location
TW
A flatness callout on a stamped part after edge trimming, can we use flatness to control the trimming edge? Is it better to use a profile callout here?

Thanks for all comments

SeasonLee
 
Sort by date Sort by votes
Though some folks will probably say that profile of surface should not be used here, I think both options are equally legal. Profile application is shown in fig. 8-27 of Y14.5-2009.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

SeasonLee
  • Question Question
Datum callout question
2 3 4
Replies
75
Views
14K
mfgenggear
mfgenggear
B
  • Question Question
Can Flatness have an associated Basic Dimension
Replies
11
Views
5K
3DDave
3DDave
B
  • Question Question
Perpendicularity callout with curved datum
2
Replies
23
Views
6K
greenimi
greenimi
rollingcloud
  • Locked
  • Question Question
Which segments does the profile callout refers to?
Replies
2
Views
355
rollingcloud
rollingcloud
Burunduk
  • Locked
  • Question Question
Profile measurement question
2
Replies
21
Views
10K
Burunduk
Burunduk

Part and Inventory Search

Sponsor

Back
Top