Flat state

[machid]

In previous version you could "control" about everything
concerning a sheetmetal-part with "edit" "setup".
The most important feature is of course the "flat state"
which gives you a sheetmetal part with family table to
control the flat pattern.

In Creo 1, I can't find that "flat state" command. Could
anyone give me a hint ???

I have found the sheetmetal properties (under File,
Prepare, model properties) , but I must say that I liked
the "setup"-way more...

Thanks in advance...

 

[kamenev]

In Creo 1 there is config option "enable_flat_state", set it to YES and goto File->Prepare->model properties->"flat state instances" entry.