Felixblanco
Mechanical
I have the same problem with flat pattern view in NX12. Suddenly, flat pattern view in drafting don't works. It shows the bent part. Do you know the solution?
thread561-422188
thread561-422188
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flat pattern view in NX12
- Thread starter Felixblanco
- Start date
- Status
- Status
Similar threads
- Question