Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flat pattern in a drawing not showing up.
- Thread starter prooney
- Start date
- Thread starter
- #2
Ok I just figured out why it was happening but don't understand how it was happening.
In part file in the feature manager design tree I had a grayed out part called "flat pattern". When I deleted this my flat pattern came up in my view palette for the drawing.
Can anyone enlighten me as to the why and how this happened?? Thanks.
In part file in the feature manager design tree I had a grayed out part called "flat pattern". When I deleted this my flat pattern came up in my view palette for the drawing.
Can anyone enlighten me as to the why and how this happened?? Thanks.
CorBlimeyLimey
Mechanical
Why did you delete the "Flat-Pattern1" feature? SW uses that feature to create the derived config for the flat pattern.
After deleting the "Flat-Pattern1" feature, did you suppress the "Process-Bends1" feature? If so, that is why the views are screwed up.
After deleting the "Flat-Pattern1" feature, did you suppress the "Process-Bends1" feature? If so, that is why the views are screwed up.
- Thread starter
- #4
There is 2 ways to create a bent sheetmetal part.
1. Create the base (bottom), then add edges to that. Final model will be folded version
2. Create the flat pattern then add bends to form the folded part. Final model will again be folded
First way will give you 2 configurations in your part, flat pattern and folded.
Second way will only give you the folded config in your part, until you go to create your drawing it will then create the other config for the flat pattern.
Insert the view you wish make sure the config is set to that and off you go.
Don't start suppressing and deleting features in your part as it could screw up the other config and give you frustrating rebuild errors.
Personnally i prefer the first method, cause i get to think less, and that makes my pay seem like more.
1. Create the base (bottom), then add edges to that. Final model will be folded version
2. Create the flat pattern then add bends to form the folded part. Final model will again be folded
First way will give you 2 configurations in your part, flat pattern and folded.
Second way will only give you the folded config in your part, until you go to create your drawing it will then create the other config for the flat pattern.
Insert the view you wish make sure the config is set to that and off you go.
Don't start suppressing and deleting features in your part as it could screw up the other config and give you frustrating rebuild errors.
Personnally i prefer the first method, cause i get to think less, and that makes my pay seem like more.
- Thread starter
- #6
- Status
Similar threads
- Locked
- Question
- Locked
- Question