Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
FLAT PATTERN EXTENDS DIMENSIONS IN PARTS LIST
- Thread starter warmblood
- Start date
- Thread starter
- #2
Found it:
In Parameters section SHEET METAL PROPERTIES -> ENABLE Thickness parameter (tick it) and create Flat Pattern First
Then paste the following in parts list field:
=<Thickness> - <Sheet Metal Width> x <Sheet Metal Length>
Hope it helps some one.
Pieter
In Parameters section SHEET METAL PROPERTIES -> ENABLE Thickness parameter (tick it) and create Flat Pattern First
Then paste the following in parts list field:
=<Thickness> - <Sheet Metal Width> x <Sheet Metal Length>
Hope it helps some one.
Pieter
- Status
Similar threads
- Locked
- Question
- Locked
- Question
