FLAT PATTERN EXTENDS DIMENSIONS IN PARTS LIST

[warmblood]

How do you read the flat pattern extend variables:
<FLAT PATTERN EXTENTS WIDTH> & <FLAT PATTERN EXTENTS LENGTH>
into a field in IProperties so it will appear on the parts list in a drawing?
Regards

Pieter

 

[warmblood]

Found it:
In Parameters section SHEET METAL PROPERTIES -> ENABLE Thickness parameter (tick it) and create Flat Pattern First
Then paste the following in parts list field:
=<Thickness> - <Sheet Metal Width> x <Sheet Metal Length>

Hope it helps some one.

Pieter