Greetings, I'm working on CATIA v5, R16. Designing mylar drill templates. I have extracted the OML surface from the wing panel and have split it to define the length and width I need for the finished product. However, I still need to create a flat pattern for this. How?????? Thanx...
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flat pattern development
- Thread starter src1750
- Start date
Similar threads
- Locked
- Question
- Locked
- Question