Flat pattern annotation

[munners]

thread561-314794

Following on from the above post I can get the flat pattern annotations to display the single label with three callouts on the flat pattern view in the model but when I add a flat pattern view in the drawing file it has three separate labels with the three separate callouts again.

Does anyone have any ideas?

Thanks

Munners

NX 7.5

 

[Arkance/PhoeNX]

You need to modify the drafting default for flat pattern views, not just the sheet metal default (see image below)

Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[munners]

Thanks Anthony