hirendhara1234
Mechanical
In 10" x Sch 40 SA 403 Type 304L 5D Pipe Bend Flaring is observed at the end portions . Is there any acceptable criteria for Flaring?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flaring in Stainless Steel 5D Pipe Bends
- Thread starter hirendhara1234
- Start date
- Status
In 10" x Sch 40 SA 403 Type 304L 5D Pipe Bend Flaring is observed at the end portions . Is there any acceptable criteria for Flaring?
