I am far in the field I am installing a pipe water line 3 kilometers long, ASTM A53 Gr B 6" Dia. 100 psi nominal presure. The piping arrived fabricated and painted with Welded neck RF flanges at de ends. And the gate valves arrived with FF flanges. What would be de consequense of joining the pipe with RF fanges to the valves with FF flanges. Thanks for the advise
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flanged joint pipe/valve FF/RF 1
- Thread starter engdrve
- Start date
-
1
- #2
pipingdesigner
Mechanical
Engdrve,
This topic had previously been discussed at length.
Follow this link:
You should get your answer here.
pipingdesigner
This topic had previously been discussed at length.
Follow this link:
You should get your answer here.
pipingdesigner
In the future, you may wish to do a search of the forum in case the topic has already been discussed.
Also, multiple posting of the same topic is discouraged. You may want to try including a link of the main thread when you post to other foras.
"Do not worry about your problems with mathematics, I assure you mine are far greater."
Albert Einstein
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
Also, multiple posting of the same topic is discouraged. You may want to try including a link of the main thread when you post to other foras.
"Do not worry about your problems with mathematics, I assure you mine are far greater."
Albert Einstein
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
- Status
Similar threads
- Question
- Locked
- Question
- Question