Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

flange raised face height tolerance

Status
Not open for further replies.

MS2017

Mechanical
Joined
Jun 1, 2003
Messages
2
Location
CA
thread408-205579



ASME PCC-2-2011
3.1 Raised Face
Under-thickness of a raised face due to refinishing
shall be acceptable, provided the minimum finished
height of the raised face is 0.8 mm (0.031 in.).



 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top